KES - FB2 - S Bending Tester
Compliance StandardsASTM D790 (Plastics Flexural Properties)ISO 178 (Flexural Strength of Rigid
E-Mail-Adresse: info@standard-groups.com
Inhalt
Compliance Standards
- ASTM D790 (Plastics Flexural Properties)
- ISO 178 (Flexural Strength of Rigid Plastics)
- SAE J2748 (Automotive Composite Flexure)
- IEC 62133-2 (Battery Module Bending)
- EN 1170-5 (GRC Flexural Testing)
Technical Parameters
| Parameter | Spezifikation |
|---|
| Force Range | 0.1N - 2000N (±0.5%) |
| Deflection Accuracy | ±1μm @ 10mm span |
| Test Speed | 0.1 - 500 mm/min |
| Support Spans | 10-500mm (adjustable) |
| Bending Radius | 0.5-100mm (±0.01mm) |
| Angular Resolution | 0.01° |
Hauptmerkmale
- 3-point & 4-point bending configurations
- Real-time curvature measurement system
- Automatic neutral axis calculation
- High-speed strain mapping (1000 fps)
- Multi-stage bend/reverse bend cycles
Test Capabilities
| Test Type | Standard | Parameters |
|---|
| Flexural Modulus | ASTM D790 | 2% strain limit |
| Bending Fatigue | ISO 12106 | 10⁷ cycles @ 20Hz |
| Springback Analysis | SAE J2748 | 180° bend + release |
Measurement System
- Dual-axis load cell (Fz + Mx)
- Laser-based deflection tracking
- Surface strain mapping via DIC
- Real-time moment-curvature plots
Standard Configuration
- Stiffness-rated frame (100kN/m)
- Interchangeable rollers (R1-R50mm)
- TestXpert III analysis software
- 2000N capacity load cell
Automotive Options
- Battery pack torsion simulation
- Seat structure cyclic loading
- Door seal compression-bend
- Thermal cycling (-40°C to 150°C)
Safety Systems
- Over-moment protection
- Emergency roller retraction
- Specimen ejection detection
- Automatic force dump circuit
Implementation Notes
- Calibrate per ISO 5893 (Roller alignment)
- Maintain 40-60% RH for polymer tests
- Use alignment jig for multi-layer stacks
- Ground isolation for electronic components
Haftungsausschluss: Die oben genannten Inhalte dienen ausschließlich zur Referenz und Kommunikation zwischen Brancheninsidern und garantieren ihre Genauigkeit oder Vollständigkeit nicht. Gemäß den einschlägigen Gesetzen und Vorschriften und den Vorschriften dieser Website sollten Einheiten oder Einzelpersonen, die verwandte Gegenstände kaufen, gültige Qualifikationen und Qualifikationsbedingungen erhalten.
